mouse abs with second monitor?

Hello, is there a way to setup bome's midi translator to send mouse abs position messages to a second or third monitor. It doesn't seem to be working for me. The mouse just ends up at the farthest point of the first monitor no matter how far i set the y axis. I searched on here and didn't find any information on this. Any help would be greatly appreciated.

bump. nobody knows anything about this?

Hi mattcoile

Sorry this got missed. Let me do some research when I'm back home (I have three monitors) and see what I can put together.

Thanks
Jared

That would be great! thanks! i've been using a workaround just by setting an abs point on the primary monitor and then using a (move mouse right) command to get it over to the other screen but it's sort of a pain to make these commands this way ( a lot of guess and check work)

I tried it as well and for me it did not work either.
Strangely, when you capture the cursor position, it seems to work.
(E.g. it shows a target point of 1041x1680)
But when you use the function/translator, it will only go to the end of the current monitor.
In this example to 1041x1080
(I have a monitor and a notebook whose screen stays below the monitor.)

Edit
For me even the work-around didn't work.
Translator 1: Mouse postion at 600x1060
Translator 2 (with a delay of 30 ms): Mouse movement by 300 pixels down

It stays at 600x1060, which is strange.

Try not using a delay but just placing the mouse movement command after the abs position command in the list and see if that works. That's how i do it and it seems to work fine (2 1080p monitors side by side). I've never tried it with a laptop so maybe that could be the problem. Not sure cause it seems like it should work with a delay command too. I'll try it when i get a chance on my desktop later

Scr1pter and mattcoile, are you on Windows or Mac? (programming the mouse is very different depending on the OS...)
Thanks,
Florian

sorry im on win7

Yes, I'm on Windows 7 as well.

I believe it's just a current limitation of MT Pro. I'll add it to the ToDo list.
Thanks,
Florian

great!