Key in disabled Windows

Hello !

I looked around a lot on this forum + internet, but was not able to find my solution.
I run on windows 7 professional and I'm trying MT to link several Mackie control devices.
I use a simple "numberpad" to switch mackie control banks to 1-8, 8-16, 16-24,...
My problem is that MT does not react when I'm using keystroke in : even if MT is not on focus, nothing is written on the Log Windows.
I do not think it's a problem of Live, as i tried it with only MT running.

I also notice that MT says when I activate a preset : "Could not load MTKeyIn.dll: key input is disabled."
Note that the keystroke output works fine.
I found the way to activate it on OSx, but I'm running on Windows and do not find the way.
Did I miss a tricky switch on MT (like "enable Key input") ?

Thanks a lot if someone has a solution !

Jérémy

Hi Jeremy,
seems like there is a configuration problem! This MTKeyIn.dll is required for keystroke input. Simplest will be to install MT Pro again (just install it over the existing installation). If the problem persists, maybe your virus scanner removed or quarantined the MTKeyIn.dll file? We've had this problem years ago with a particular virus scanner.

Best regards,
Florian

Hi,

Thanks for your super quick answer !!!

I try that and tell you.

Best regards,

Jérémy

Hi,

Works fine, thanks !!!

Best regards,

Jérémy